• head_banner_01

Products

Battery combustion tester

Short Description:

The battery combustion tester is suitable for lithium battery or battery pack flame resistance test. Drill a 102mm diameter hole in the experimental platform and place a wire mesh on the hole, then place the battery on the wire mesh screen and install an octagonal aluminium wire mesh around the specimen, then light the burner and heat the specimen until the battery explodes or the battery burns down, and time the combustion process.


Product Detail

Product Tags

Battery Combustion Tester Precautions

1. Please ensure that the power and gas sources are properly plugged or connected before preparing for the test.

2. It is strictly prohibited to operate the machine when in close proximity to it.

3. Regular maintenance of the mechanical transmission parts is necessary.

4. After completing the test, please ensure that the power supply is switched off.

5. It is strictly prohibited to clean the machine with corrosive liquids. Please use anti-rust oil instead.

6. The test machine must be used exclusively for its intended purpose. Knocking or standing on the machine is strictly prohibited.

7. The machinery must be properly grounded.

Application

control method PLC Touch Screen Control System
inner dimension 750x750x500mm(W x D x H)
outer dimensions 900x900x1300mm(W x D x H)
Inner box material SUS201 stainless steel plate, thickness 1.2mm
Outer case material Thickness 1.5mm Cold rolled steel plate with baked enamel finish
viewing window Two layers of toughened glass, size 250x250mm, transparent window with stainless steel mesh.
smoke vent 100mm diameter on the rear side of the box
pressure relief port Opening size 200x200mm, located at the back side of the box, when the specimen explodes, the pressure relief port pops open to remove the pressure.
door Single door left open, the door is equipped with a safety limit switch, the side is equipped with explosion-proof chain, close the door before you can operate the equipment, to ensure personnel safety.
burners 9.5 mm inner diameter of the nozzle, approx. 100 mm long
burn time (0-99H99, H/M/S units switchable)
Test hole diameter 102mm
Test Mesh Screen Specifications Mesh screen made of 0.43mm diameter stainless steel wire with 20 meshes in US inches.
Flame to screen height 38mm

  • Previous:
  • Next:

  • Write your message here and send it to us